Wheelchair shower that allows you to sit in the bath or shower and can also be used as a toilet. Can also be used for the transport of persons to and from the bathroom or toilet.

E 'equipped with a tilt function that allows you to tilt the seat from from -6.5 ° to +25.5 °. To activate the tilt function to pull up the lever on the handlebar basculamentoche is thrust.

E 'equipped with 4 wheels braked 5 ", with toilet bucket with removable lid, with headrest adjustable in height, depth and tilt. The seat, backrest and armrests are soft PUR black. Footrests are removable and adjustable in height . The seat is also provided with a central opening for the use of the bucket mounted under the seat itself.

The comfortable rocking chair h8916 comes disassembled in a cardboard box.

The supply consists of the following parts:

• 1 base frame with seat in black PUR
• 1 back with back-rest and armrests in black PUR
• 1 removable headrest and adjustable in height, depth and tilt
• 2 removable and height adjustable footrest
• 4 removable wheels with parking brake
• 1 toilet bucket with handle and lid
• 1 cover with PUR black the groove in the session
• a manual

Technical detail:

• folding armrests
• max. 130 kg
• weight 15.10 kg 18 kg
• seat depth 42 cm
• seat width 44.50
• width max. between armrests 46.5 cm
• width max. 57 cm
• height reg. (Without headrest, receiver at 0 °) 85 - 111 cm
• seat height, adjustable 53.5, 56 or 58.5 cm
• tilt by -6.5 ° to +25.5 °
• Conforms to CE marking Directive 93/42/EEC of 14 June 1993appendice I concerning medical devices

Assembly:

• Turn the bearing frame upwards and place it on the ground in such a way that in the 4 tubes you see the holes where they will be inserted the vertical tubes with the wheels
• 4 wheels mounted by entering each vertical tube until it stops in the holes of the frame.
• Fixed now with the through screws supplied with each wheel to the chassis.
• Double check that the wheels are set trying to remove the wheels trying to pull the tube from the frame.
• Now stir the frame in the correct position so that it rests on the 4 wheels
• Before proceeding with the assembly block all the wheels by pressing the tip of the foot on the brake tabs found on each of the wheels
• To release the brakes after assembly raised from below with the tip of the foot brake the tabs
• Insert lower tubes back into the holes on the rear of the chassis
• Fixed to the backrest frame by screwing the two knob screws so that the seatback is locked to the frame
• Insert the tube in the headrest 'frame of the support fixed to the handlebars of the wheelchair push
• After recording the headrest to the desired height, secure it to the bracket by tightening the knob to star in a way that does not leave more to move up or down
• Place the lid on the bucket toilet
• Place the bucket from behind the rails support placed under the seat and push it to the stop avantifino
• Place the cover on the PUR black hole for the WC
• Place the leg support turned outward in the front holes of the frame
• Turn now the leg support 90 ° inwards until you hear it clicks into place
• Subsidiaries that do not allow themselves to be run without pulling the locking lever, otherwise sonoinseriti properly